Zscaler favicon

Zscaler outage on 2026-11-12

zscaler.com
November 2026 12 Minor incident

Zscaler's Admin UI went down for 42 minutes starting at 06:44 UTC on 12 November 2026. The fault sat on Zscaler's side, in the console you use to manage policy, not in the traffic path itself.

Started

06:44 UTC

Duration

Lasted 42m

Source

IsDown

Next time

Zscaler is degraded. Is your product working?

An incident on their side does not always mean an outage on yours, and the only way to know is to already be watching your own endpoints. Set that up in under a minute and you will be notified the next time your own site is affected. And there will be a next time.

50 monitors for your own websites. No card.

Affected components: Admin UI

What happened?

Zscaler logged one incident on this day, titled "Administration UI Issue", starting at 06:44 UTC and lasting 42 minutes. The only component listed is the Admin UI, which is the console administrators use to configure policy and view settings, separate from the traffic-handling edge that actually routes and filters your connections. Zscaler filed no updates against this incident, so there is no note on what triggered it, no indication of partial versus full unavailability, and no confirmation of what fix, if any, was applied before it closed. No user reports were filed during the window on this page. Zscaler's own status page is the only source for this incident, and with zero updates attached, it carries limited detail beyond the fact that it happened and how long it lasted. Over the past 90 days Zscaler has logged 37 incidents with a median duration of 1 hour 48 minutes, so this one resolved well under that typical length. Across all time, Zscaler averages 8.9 incidents a month over 382 total. There is nothing here to suggest this outage extended to policy enforcement, authentication or data routing, since those are separate components that Zscaler did not list as affected.

Learning

Our own probes watch the edge component, which is the part of Zscaler that actually carries your traffic, and across the EU and North America it read 100% uptime over the past 24 hours. That is not a contradiction with Zscaler's reported Admin UI incident, it is two different layers of the same product. The console you use to configure Zscaler can go down while the traffic path it configures keeps running unaffected, because the enforcement layer does not need the admin panel to stay up once policy is already in place. This is a shape worth recognising in your own stack: a management plane outage rarely shows up as a user-facing failure, but it can leave you unable to make changes, pull logs or respond to a separate problem while it lasts. Our 30-day figures show 11 incidents for Zscaler, all resolved, with a median duration of 1h 35m, which gives you a sense of how often this kind of thing recurs even when the edge stays green throughout. Watching only your own endpoints would not have told you the Admin UI was unreachable, since nothing about your traffic would have changed. Your monitoring covers your half, UptimeRobot now watches the provider's half too, so next time you know which side broke without guessing.

4.7
stars out of 5
284+ reviews on

Start monitoring in 30 seconds.

There's nothing to install. No credit card required. 50 monitors for free.